true position problems!!

hello there! so i've been having problems fixing this true position dimension. say the part location, on x and y are 1.0 x 1.0 true position of .005. but if my nominal says its 1.005 x 1.007 and i can't change that! because my actual readings are of 1.001 x 1.003. so because i cannot change my nominals, the report states its out of print. I already went and changed the nominals manually on the program. also on the advanced tap on true position, checked and unchecked "update feature nominal" but nothing seems to change those numbers. Any help will be appreciated. Thank you.

Parents

Nano Vujkovic over 10 years ago

thanks for replying well it does seem that the cad is incorrect. but i started from scratch, not using the cad and it still does the same. and yes the code does go through.

What are the nominals in the feature compared to nominals in the dimension?
Posting code on the forum would help us figure out whats going on in your program.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Nano Vujkovic over 10 years ago

thanks for replying well it does seem that the cad is incorrect. but i started from scratch, not using the cad and it still does the same. and yes the code does go through.

What are the nominals in the feature compared to nominals in the dimension?
Posting code on the forum would help us figure out whats going on in your program.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data