hello there! so i've been having problems fixing this true position dimension. say the part location, on x and y are 1.0 x 1.0 true position of .005. but if my nominal says its 1.005 x 1.007 and i can't change that! because my actual readings are of 1.001 x 1.003. so because i cannot change my nominals, the report states its out of print. I already went and changed the nominals manually on the program. also on the advanced tap on true position, checked and unchecked "update feature nominal" but nothing seems to change those numbers. Any help will be appreciated. Thank you.
FIT TO DATUMS=YES Should be
NO unless the Datums also have modifiers. If the Position tolerance specifies MMC or LMC, then that only applies to the feature, not the datums.
OUTPUT ALIGNMENT=Datum Reference Frame Should perhaps be
Current Alignment
FIT TO DATUMS=YES Should be
NO unless the Datums also have modifiers. If the Position tolerance specifies MMC or LMC, then that only applies to the feature, not the datums.
OUTPUT ALIGNMENT=Datum Reference Frame Should perhaps be
Current Alignment
