I have a fixture that holds 10 parts. Let's say I have to run 50. How do I have the report continue with the eleventh part? Meaning once all 10 have run. It starts back at one in the report. I am new to the logic part of the software....obviously
The question that you are asking is potentially pretty complicated and will take a long time to explain in sufficient detail. It has probably already been addressed in whole or in part on this forum in the past so you can very likely piece together an answer without having to wait for someone to respond to you. I was just trying to point you in the direction of digging through the information that is already available here so you can hopefully make progress on your own. There are hundreds of threads on here about looping, using fixtures to measure multiple parts, etc.
The question that you are asking is potentially pretty complicated and will take a long time to explain in sufficient detail. It has probably already been addressed in whole or in part on this forum in the past so you can very likely piece together an answer without having to wait for someone to respond to you. I was just trying to point you in the direction of digging through the information that is already available here so you can hopefully make progress on your own. There are hundreds of threads on here about looping, using fixtures to measure multiple parts, etc.
