Update dependant commmands prompt is not appearing

Try F5/Warnings -
This one could be "Off".

That was it.

People were being 'helpful' by getting rid of the warnings.....

Same issue, prompt is not coming up (someone was being "helpful")

Looked in F5/ Warnings, but there is no check box for this prompt, it is not listed...
Looked in the setting editor at the Update Below Changed Alignment during Execution entry. The current value is 0.

How can I get this prompt back?

Are your coordinates changing when you update? The window will not prompt, nothing theoretically changes within the alignment.
Test out how its functioning: If you do invoke a coordinate change (add an offset of some arbitrary number in one axis to test), do the feature coordinates below, change? or no change?

If I change an alignment / co-ordinates it is changing everything below. No prompt, but seems to be defaulting to as if yes were clicked

I'm pretty sure this is the bandwagon I need to be on.

I have had more than one program, recently written, all in 2018, that continues to change feature coordinates in everything below an alignment. My "recalled" alignment COULD be affecting it, but since I am changing the zero point on the last measured feature, I'm expecting feature coordinates below the alignment to remain where I left them.

Example: I measure a feature that I measured the last time I ran the program and it's moved a little. In one case a slot that is 3.05 mm tall on a YZ plane. The alignment in the tool that stamped and formed the part wasn't correct so the slots can actually seem to be lower on some parts and higher on others. Touch the bottom of the bottom slot, set zero in Z. Now touch the top of the same slot and it didn't usually run too bad, but could. Limp through by slightly changing the Z move on that point. Touch the front and rear of the same slot (last time I ran it five minutes ago I changed these moves to be 1.5 mm in Z (halfway up the height of the slot) but now, after setting zero for Z on this current slot, those drive moves are near to zero, sometimes in the negative. Won't run. reset to 1.5, goes on. Slots directly above this slot now also all have to be modified. Wash, rinse, repeat, repeat, repeat....

Is this something new that is occurring with 2018? (Corporate is sending me my more recent licenses, but not sweating that yet). It's alot like the old Lotus 1-2-3 relative vs. absolute feature types. Is there a setting I am missing? H-E-L-P.

Thank you!

Not sure about a setting but you can add a "+0" to each of your nominals to keep them from changing. ie. (1.5+0, 3+0, 3.05+0)

Does your alignment lock all 6 DOF?

After research in this thread I was able to restore my warnings and move past this particular issue. Thanks.