How can I get the header to print on every report when using loops? We have several fixtures we use to locate parts when inspecting them with the CMM. So to save time, we loop back to the part to eliminate the need to take the hits on the fixture every time. However, the header does not print out on any of the reports after the first part is checked.
If you don't need it on every page, but just at the beginning of each loop put the cursor at the beginning of the loop and from the menu select Insert/Report Command/Report Label, then select "FILE_HEADER.LBL"
The only problem would be double header on the first report, but you could always put a Form Feed command(from the same place in the menu as above) before the loop starts to give a clean slate.
If you don't need it on every page, but just at the beginning of each loop put the cursor at the beginning of the loop and from the menu select Insert/Report Command/Report Label, then select "FILE_HEADER.LBL"
The only problem would be double header on the first report, but you could always put a Form Feed command(from the same place in the menu as above) before the loop starts to give a clean slate.
