True Position ISO 2768-m

I am currently programming a job from drawing with a hole with no true position specified, it has boxed dimensions which would imply a true position. I've notified the customer to ask what the true position would be and they said I should be able to get the true position from the ISO Spec?

To my knowledge the ISO specification used being ISO 2768-m does not specify a true position to use for boxed dimensions with no positional tolerance, this is usually illustrated on the drawing in a tolerance frame around the hole call out? I'm looking to reply with words to that effect, am I right to say this?

I've checked the standard and I can't see anything on this, any advice would be greatly appreciated

(see attached image)

Parents

GEO3D over 8 years ago

I don't have a specific answer, but don't you love when you ask your customer for information and their answer is basically to figure it out your **** self?

Sorry I'm not much help GEO

Haha you are right, that is the customers way of batting the problem straight back to you quickly with little effort on their behalf
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

GEO3D over 8 years ago

I don't have a specific answer, but don't you love when you ask your customer for information and their answer is basically to figure it out your **** self?

Sorry I'm not much help GEO

Haha you are right, that is the customers way of batting the problem straight back to you quickly with little effort on their behalf
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data