Is it possible to extract the sample points taken on a diameter (Auto CIR or Auto CYL)? I have to measure the surfaces around some holes on an assembly and the hole locations and would just add more sample points than the standard (3) instead of measuring the diameter and measure a plane.
Does anyone know for sure how "sample hits" are probe compensated - nominal direction or in the direction of the created 'plane'? Will extracting those points be equivalent to actually measuring a plane at exactly the same coordinates?
Maybe there's a reason for the 'unavailability' of the sample hits?
Does anyone know for sure how "sample hits" are probe compensated - nominal direction or in the direction of the created 'plane'? Will extracting those points be equivalent to actually measuring a plane at exactly the same coordinates?
Maybe there's a reason for the 'unavailability' of the sample hits?
