I have a Pallet that has (4) cones. There is a dimension from the bottom of the Pallet over an Ø85.000 MM gage ball. Is there a way to create the gage ball tangent to the cone?
Cone.pdf
Use circle construction. Under type of construction, select cone. Then for type of cone construction, select sphere. It will construct a circle at the tangency height. Then just create a point offset half the diameter from the circle.
Use circle construction. Under type of construction, select cone. Then for type of cone construction, select sphere. It will construct a circle at the tangency height. Then just create a point offset half the diameter from the circle.
