I have a Pallet that has (4) cones. There is a dimension from the bottom of the Pallet over an Ø85.000 MM gage ball. Is there a way to create the gage ball tangent to the cone?
Cone.pdf
What you can try is create autopoints on two opposite sides of the c-sink construct 2x 3D lines & construct a circle tangent to these two lines. I saw over the pin dimensions done this way. It should work with spheres too.
What you can try is create autopoints on two opposite sides of the c-sink construct 2x 3D lines & construct a circle tangent to these two lines. I saw over the pin dimensions done this way. It should work with spheres too.
