Gage Ball in Cone

I have a Pallet that has (4) cones. There is a dimension from the bottom of the Pallet over an Ø85.000 MM gage ball. Is there a way to create the gage ball tangent to the cone? Cone.pdf

Parents

MattR over 8 years ago

That's an interesting idea, but wouldn't you want 2D lines? You are suggesting that he recreate the 2D view exactly as it appears on the drawing.

I think so. The way it looks it is over the pin dimension. But anyway, I think it could work either way. You might want to try construct 2D line from autopoints using best fit & then check graphics display window if this line goes thru all of those autopoints. If that don't work try 3D line & best fit. I usually try different options to see which one is fits best. And there is plenty of them in the software. Hope this helps.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

MattR over 8 years ago

That's an interesting idea, but wouldn't you want 2D lines? You are suggesting that he recreate the 2D view exactly as it appears on the drawing.

I think so. The way it looks it is over the pin dimension. But anyway, I think it could work either way. You might want to try construct 2D line from autopoints using best fit & then check graphics display window if this line goes thru all of those autopoints. If that don't work try 3D line & best fit. I usually try different options to see which one is fits best. And there is plenty of them in the software. Hope this helps.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data