Tried
- new probe files
- different Z-heights
- different lightning
- different backgrounds
- different surfaces
I can visually "see" that it does focus very well, during the autofocus phase - however, it does not seem to "lock" or "detect" this...
CMM-V (HP-C-VE) in 2016.0 SP1.
It says HP-C-VE on the can, but even if I change it to "CMM-VE" in the probefile, it can't focus (not tested in a calibration, only focus on part).
Regarding controller reset, we shut the power off (not the big MAIN switch though), don't really know how to do a controller reset...
The only thing that (should) have changed after S&C is that the controller firmware has been updated. Also, the error message is not the focus error, but more a ReadPos error...
It says HP-C-VE on the can, but even if I change it to "CMM-VE" in the probefile, it can't focus (not tested in a calibration, only focus on part).
Regarding controller reset, we shut the power off (not the big MAIN switch though), don't really know how to do a controller reset...
The only thing that (should) have changed after S&C is that the controller firmware has been updated. Also, the error message is not the focus error, but more a ReadPos error...