Good morning all I hope you are all having a good day, I have a program that contains a simple loop to check multiple pockets on a valve rotator body, We have recently set up a few other machines to make the same part and I want to loop the entire program Loop included to check multiple parts at once.
My question is, can you Loop a Loop?
Or will the end point of the Loop checking multiple pockets cancel out the Loop that would be needed at the start of the program.
I have done multiple loops before where I have measured a 4x3 grid of separate parts and that worked well. I havnt done a loop of parts with a loop of features in the middle of them but the theory is the same so should work.
save the program, make a copy and give it a try is the best way.
I have done multiple loops before where I have measured a 4x3 grid of separate parts and that worked well. I havnt done a loop of parts with a loop of features in the middle of them but the theory is the same so should work.
save the program, make a copy and give it a try is the best way.