Read point alignment.

Good day all,
I am attempting to start programming using a read point alignment. I am either not doing it right at all or I think the issue might be that I am using clearance cube.

any help is much appreciated.

tia

Parents

mb0258 over 7 years ago

LOADPROBE/PROBE_1
            TIP/T1A0B0, SHANKIJK=0, 0, 1, ANGLE=0
            COMMENT/OPER,NO,FULL SCREEN=YES,AUTO-CONTINUE=NO,
            PLACE THE PROBE INSIDE
            THE CENTER OF STARTING POSITION
            PREHIT/5
            RETRACT/5
            CHECK/10,1
PNT_READ   =FEAT/POINT,CARTESIAN
            THEO/<0,0,0>,<0,0,1>
            ACTL/<445.0986,261.7209,-435.0063>,<0,0,1>
            READPOINT/
ALN_READ   =ALIGNMENT/START,RECALL:STARTUP,LIST=YES
            ALIGNMENT/TRANS,XAXIS,PNT_READ
            ALIGNMENT/TRANS,YAXIS,PNT_READ
            ALIGNMENT/TRANS,ZAXIS,PNT_READ
            ALIGNMENT/END

PNT_READ (CTRL+ALT+G, I think

) have to have THEO values same as nominals of your CAD/drawing, so If You have model, You need to have origin 0,0,0 of CAD model in same place as your start position.

Reply

mb0258 over 7 years ago

LOADPROBE/PROBE_1
            TIP/T1A0B0, SHANKIJK=0, 0, 1, ANGLE=0
            COMMENT/OPER,NO,FULL SCREEN=YES,AUTO-CONTINUE=NO,
            PLACE THE PROBE INSIDE
            THE CENTER OF STARTING POSITION
            PREHIT/5
            RETRACT/5
            CHECK/10,1
PNT_READ   =FEAT/POINT,CARTESIAN
            THEO/<0,0,0>,<0,0,1>
            ACTL/<445.0986,261.7209,-435.0063>,<0,0,1>
            READPOINT/
ALN_READ   =ALIGNMENT/START,RECALL:STARTUP,LIST=YES
            ALIGNMENT/TRANS,XAXIS,PNT_READ
            ALIGNMENT/TRANS,YAXIS,PNT_READ
            ALIGNMENT/TRANS,ZAXIS,PNT_READ
            ALIGNMENT/END

PNT_READ (CTRL+ALT+G, I think

) have to have THEO values same as nominals of your CAD/drawing, so If You have model, You need to have origin 0,0,0 of CAD model in same place as your start position.

Children

No Data