Good day all,
I am attempting to start programming using a read point alignment. I am either not doing it right at all or I think the issue might be that I am using clearance cube.
Don't know if this wil solve the Out of tolerance problem............ Move your Mode/DCC to after the readpoint alignment. Hopefully your move point is not driving into the table...
Just tried that. Want to move in Z 18 inches OUTTOL.
Don't know if this wil solve the Out of tolerance problem............ Move your Mode/DCC to after the readpoint alignment. Hopefully your move point is not driving into the table...
Just tried that. Want to move in Z 18 inches OUTTOL.