Using 2017 I'm running an existing program. I use "find Center" for the square slots I'm measuring. Now when it tries to find the center the probe just keeps driving into the hole until the module hits the part surface. I have the depth set for .1 inches. I have never had this problem
Honestly, I am glad you have ran into this problem. I experienced the same thing rolling out 2017 that I did not see in the tech preview. I just haven't had time to dig into it to validate the problem. Currently still running latest version of 2016.0 with no problems.
The program that was problematic for me works in 2016.0 SP5 and errors out in 2017. Hopefully, later this week I will have time to dig into this on my end. Been a busy last couple weeks...
Honestly, I am glad you have ran into this problem. I experienced the same thing rolling out 2017 that I did not see in the tech preview. I just haven't had time to dig into it to validate the problem. Currently still running latest version of 2016.0 with no problems.
The program that was problematic for me works in 2016.0 SP5 and errors out in 2017. Hopefully, later this week I will have time to dig into this on my end. Been a busy last couple weeks...
