GD&T Help_Sanity Check

Can someone help me explain this GD&T on the right to my management?

A is a plane on top facing Z+, D is the inside diameter, C is the width at 12oclock. We're looking specifically at the composite portion of the DRF.

Thank you all

Parents

VinniUSMC over 7 years ago

The holes individually must fall within the .005 tolerance zone, and simultaneously, the two holes must be positioned within .002 of each other. (Basically, they cannot be more than .002 apart from each other at any point, or parallelism, if you wish).
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
KIRBSTER269 over 7 years ago in reply to VinniUSMC

2 fingers here unless I'm holding my head up, then just one
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

KIRBSTER269 over 7 years ago in reply to VinniUSMC

2 fingers here unless I'm holding my head up, then just one
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data