2 Datum Alignment

Can someone please help me figure out the best way to set up an alignment with only 2 datums? The print I am working off only has a datum A plane and a datum b diameter and is wanting some gd&t position information just using A & B instead of the A, B and C that I am used to.

Thanks

Parents

JEFMAN over 7 years ago

I would say : construct your alignment as you want (with 6 DOF !), then use FCF with 2 datums, and it should work...
(I'm not at the cmm to check it...)
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

JEFMAN over 7 years ago

I would say : construct your alignment as you want (with 6 DOF !), then use FCF with 2 datums, and it should work...
(I'm not at the cmm to check it...)
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data