I'm trying to create a scanning report that one of our engineers is looking for. I'm attaching a picture but what they want to see is an outline of the low tolerance of a profile, an outline of the max outline of a profile and an outline of where the part actually measured on that profile. They also want arrows like the ones displayed in the picture I'm attaching that show a direction that the measured surface is out of tolerance in areas that are out of spec. I know that this is being displayed in the graphics display window I'm just not sure how to get the arrows. Any advice?
^^this^^
in addition, if using XactMeas, you can go to the advanced settings (second tab or the like) and set the graphical to form, form + location, size multiplier etc., In analysis view, more options like show/hide tolerance band, percent of arrows, etc...
In the analysis view window select "options" then "dimension options", after that select "Show max/min deviations" (see attached). Hope this is what you are trying to achieve in the report view?
