Can someone please help me understand how PC-DMIS calculates angularity. I'm checking the angularity between two lines that are called out at 45 degrees and the angle is measuring 44.89 which is well within spec. The angularity callout is 6.3 but on the legacy angularity dimension it is giving me a measured value of 35.001. ????
I would check the workplane...
35 mm of angularity shouldn't result of a machining defect (except if the operator has drink too much !), I think it's a construction error...
I would check the workplane...
35 mm of angularity shouldn't result of a machining defect (except if the operator has drink too much !), I think it's a construction error...
