I've got 2 parts, mirrored in Y, on one fixture. The fixture has 3 tooling balls, each with 2 sets of coordinates, one set for each part. Is there a way for me to write both parts into one program without having to pick up the tooling balls more than once?
Yes and no. Yes, you can manually measure as few of them as 1, but in DCC you will have to measure them all twice. IMO, I wouldn't measure the t-balls for the final DCC alignment, I would measure the net pads and locator pins/bushings.
Yes and no. Yes, you can manually measure as few of them as 1, but in DCC you will have to measure them all twice. IMO, I wouldn't measure the t-balls for the final DCC alignment, I would measure the net pads and locator pins/bushings.
