I've got 2 parts, mirrored in Y, on one fixture. The fixture has 3 tooling balls, each with 2 sets of coordinates, one set for each part. Is there a way for me to write both parts into one program without having to pick up the tooling balls more than once?
You should be able to measure the tooling balls in DCC or however you typically do your alignment to that fixture-program part 1 then recall that fixture alignment and do the same on second part to keep this to a single program.
You should be able to measure the tooling balls in DCC or however you typically do your alignment to that fixture-program part 1 then recall that fixture alignment and do the same on second part to keep this to a single program.
