Good evening,
What is the best way to measure threads on the CMM? I would just use a thread gage and put it in the report but I was asked to write them in the program. Thank you in advance.
When I measure threads I select a tip large enough to not "fall in" and I take a few linear scans along the direction of the shanks vector. I can't say that this is the best way, just how I do it.
When I measure threads I select a tip large enough to not "fall in" and I take a few linear scans along the direction of the shanks vector. I can't say that this is the best way, just how I do it.