Good evening,
What is the best way to measure threads on the CMM? I would just use a thread gage and put it in the report but I was asked to write them in the program. Thank you in advance.
Because a cylinder probe cannot be made or qualified to be physically square to any of the CMM axis, because of this you will get an incorrect reading for the position of the threaded hole. If you use a spherical probe it doesn't need to be, as there is a distance between the ruby and the shank that holds the ruby.
Because a cylinder probe cannot be made or qualified to be physically square to any of the CMM axis, because of this you will get an incorrect reading for the position of the threaded hole. If you use a spherical probe it doesn't need to be, as there is a distance between the ruby and the shank that holds the ruby.