Workplanes for Auto Features

Hello everyone! I'm back with a basic question that I should probably already know...

Do I need to worry about workplanes or projection when working with auto features? For example I have two holes that I'm measuring as circles after selecting the holes on the CAD with the circle auto-feature. I haven't seen it make a difference, but I've been changing the workplane/projection every time since I started programming a couple months ago.

Parents

Alucard over 5 years ago

...not for measuring them, but 2D evaluations are workplane-dependent, regardless of feature type.

Oh...okay, so if I understand you correctly, I will need to tell the program to reference the workplane prior to reporting the position at the end of the program? Also, do I just click the dropdown for the projection plane (if projecting to a plane) or just select Z+ plane (assuming the holes are parallel to Z+)? I've noticed selecting a work plane adds a code line, but selecting a projection plane doesn't appear to change anything in the code.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
vpt.se over 5 years ago in reply to Alucard

Learned (measured non-autofeatures) features, needs a "projection plane", ie. workplane. You can "hardcode" the plane (X/Y/Z plane) so it always uses that particular workplane or choose "workplane" in the feature, which will use the currently selected workplane in the program (in the code).
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

vpt.se over 5 years ago in reply to Alucard

Learned (measured non-autofeatures) features, needs a "projection plane", ie. workplane. You can "hardcode" the plane (X/Y/Z plane) so it always uses that particular workplane or choose "workplane" in the feature, which will use the currently selected workplane in the program (in the code).
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data