Auto-Cylinder vs Circles Constructing a Cylinder: For Perpendicularity

Which is more accurate, the auto-cylinder to plane OR 3 auto-circles (constructing a best fit, least squared, cylinder) to plane.

Essentially they should have the same result, correct?

When I run it I have a 0.0009 difference between the results.

Which number should I trust?

(I am building off of an IGES file)

Looking at previous posts I made sure that I had it set to Perp to Datum

Parents

AndersI over 6 years ago

Just be careful - the definition of "Projected zone" is not exactly the same as "Calculation length" - it works for parallelity, angularity and perpendicularity to set the length with (P), as these properties are unaffected by the position. Don't try this trick on a POSITION, CONCENTRICITY or SYMMETRY unless the print actually has a (P)!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
AndersI over 6 years ago in reply to AndersI

Ahh, that situation can be tricky to detect!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

AndersI over 6 years ago in reply to AndersI

Ahh, that situation can be tricky to detect!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data