Feature Set to Surface Profile

Hi, I am new to the forum so please be considerate.

When you are creating a feature set and say you put in a circle, a line, and a plane, to create (scn1) when you output (scn1) as a profile Form+Location and MaxMin does this give you the profile of each individual point in those features or a profile of the centroids of those features?

If the centroids, Is there an easier way other than probing all the points over again or probing all the points and then creating your features to get what I am looking for?

Thank you for your help!

Parents

AndersI over 5 years ago

PROFILE compares each hit against its nominal value (or re-pierces the CAD if FINDNOMS is ON), not to the geometric form of the original feature. We don't know what DATUM A is, or how it is measured - it needs to be an autofeature (clicked on CAD or numerically entered) to have real nominals on every hit. If it is a "measured feature", the nominal value for each hit is equal to the measured value when the program was learned, and no form deviation will be detected in the original run. If you run the program again (preferrably on another part) you would probably get higher numbers, but still wrong.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
AndersI over 5 years ago in reply to AndersI

What value does FLATNESS of DATUM A give?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

AndersI over 5 years ago in reply to AndersI

What value does FLATNESS of DATUM A give?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data