Feature Set to Surface Profile

Hi, I am new to the forum so please be considerate.

When you are creating a feature set and say you put in a circle, a line, and a plane, to create (scn1) when you output (scn1) as a profile Form+Location and MaxMin does this give you the profile of each individual point in those features or a profile of the centroids of those features?

If the centroids, Is there an easier way other than probing all the points over again or probing all the points and then creating your features to get what I am looking for?

Thank you for your help!

Parents

JEFMAN over 2 years ago

Comparing the centroid to the cad depends on the number of hits, so you can't get a accurate comparison... (I guess the cad centroid is calculated from a infinity number of "hits")

average	X	Y
181 hits	31,7930475	31,7930475
91 hits	31,7551237	31,7551237
61 hits	31,7172169	31,7172169
31 hits	31,6035962	31,6035962
16 hits	31,3767761	31,3767761
11 hits	31,1504653	31,1504653
6 hits	30,4739646	30,4739646
3 hits	28,4517797	28,4517797

Reply

JEFMAN over 2 years ago

Comparing the centroid to the cad depends on the number of hits, so you can't get a accurate comparison... (I guess the cad centroid is calculated from a infinity number of "hits")

average	X	Y
181 hits	31,7930475	31,7930475
91 hits	31,7551237	31,7551237
61 hits	31,7172169	31,7172169
31 hits	31,6035962	31,6035962
16 hits	31,3767761	31,3767761
11 hits	31,1504653	31,1504653
6 hits	30,4739646	30,4739646
3 hits	28,4517797	28,4517797

Children

No Data