I am trying to set up barcode scanners on our CMMs so that when the operator puts a part on the fixture, they will scan the part and it will automatically open the proper program. If this kind of thing possible? I have seen some people using scanners to add data via comments, but is it feasible to scan a part and have it open the corresponding program?
JoBarcode is an old program, and only supported on the Nordic market. Take a look at
Inspect instead - it's part of the PC-DMIS installation if you have a recent version.
I think both programs currently have the same limitation - the barcode must
be the part program name. JoBarcode will not change, Inspect is actively updated, and you can suggest improvements on the userecho pages,
https://hexagonmi.userecho.com/
JoBarcode is an old program, and only supported on the Nordic market. Take a look at
Inspect instead - it's part of the PC-DMIS installation if you have a recent version.
I think both programs currently have the same limitation - the barcode must
be the part program name. JoBarcode will not change, Inspect is actively updated, and you can suggest improvements on the userecho pages,
https://hexagonmi.userecho.com/