how to increase speed?

Hi All
I use PC-DMIS CAD++ 2019 R1 on B&S 5.7.5, its absolute speed is 700 (this is what I see when I open F5 ). Most of our programs run with speed 200-300mm/s. I changed it to 500 in program edit window but didn't see any difference.
I searched forum and found information that I can change speed in machine interface setup, so I did, under "Params" tab I changed x,y,z max speed to 500. But I couldn't run any program. Right after I start it gives me execution error "move absolute to...." no even error#. Is this speed limited somewhere else?
Please help
Thanks,
Ewa

Parents

louisd over 5 years ago

I searched forum and found information that I can change speed in machine interface setup, so I did, under "Params" tab I changed x,y,z max speed to 500. But I couldn't run any program.

This is the acceleration parameters. That value should be significantly higher than 500, but this isn't going to speed up your routine by much at all. here's a link related to accel parameters https://www.pcdmisforum.com/forum/pc-dmis-enterprise-metrology-software/pc-dmis-for-cmms/23428-acceleration-parameters
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

louisd over 5 years ago

I searched forum and found information that I can change speed in machine interface setup, so I did, under "Params" tab I changed x,y,z max speed to 500. But I couldn't run any program.

This is the acceleration parameters. That value should be significantly higher than 500, but this isn't going to speed up your routine by much at all. here's a link related to accel parameters https://www.pcdmisforum.com/forum/pc-dmis-enterprise-metrology-software/pc-dmis-for-cmms/23428-acceleration-parameters
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data