how to increase speed?

Hi All
I use PC-DMIS CAD++ 2019 R1 on B&S 5.7.5, its absolute speed is 700 (this is what I see when I open F5 ). Most of our programs run with speed 200-300mm/s. I changed it to 500 in program edit window but didn't see any difference.
I searched forum and found information that I can change speed in machine interface setup, so I did, under "Params" tab I changed x,y,z max speed to 500. But I couldn't run any program. Right after I start it gives me execution error "move absolute to...." no even error#. Is this speed limited somewhere else?
Please help
Thanks,
Ewa

Parents

dwade over 5 years ago

Lesson learned in ABSOLUTE vs. PERCENT, if you share programs you will see a better correlation between CMMs if you use ABSOLUTE for TOUCHSPEED. Another thing to think about when trying to increase your speeds is that unless there is ample distance between move points you may not see much of an increase because of acceleration and deceleration limits of the controller. When I'm sending the probe to and from the rack for changes I'm usually maxing out the MOVESPEED of the controller
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
anthony.alfaro over 5 years ago in reply to dwade

Bingo.

If you run the same programs on multiple machines, its always better to run them in absolute rather than percent or relative.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

anthony.alfaro over 5 years ago in reply to dwade

Bingo.

If you run the same programs on multiple machines, its always better to run them in absolute rather than percent or relative.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data