I have a part with 2 face call out. i finish programing one face but now need to flip the part and program the other side. my question is how can i flip the part on pcdmis and change my Z with out anything moving. each time i try to flip or rotate my z and everything i program moves. i don't want to create two different programs because on the second face, holes call for tp and the datums are located in the first face. i cant set this part on a fixture where i can have asses to all faces in one program on the cmm.
I would set it 'on edge' and check it that way. no problem reaching everything with 1 setup and 1 alignment, like the middle view, part 'on edge' not on flat.
Matthew could you explain to me what you mean by "on Edge". I did try to figure out away with a fixture and tried to get creative but I ran out of ideas and this part is way to heavy to be moving around a lot
Matthew could you explain to me what you mean by "on Edge". I did try to figure out away with a fixture and tried to get creative but I ran out of ideas and this part is way to heavy to be moving around a lot
