Anyone know how to remove the bar with CAD, Vision and Laser? I'm only working in CAD and it's not a big deal when working from home, but my work monitor is much smaller than my at-home setup and the bar is eating up real estate.
To run PC-DMIS without any vision functionality you would need to add the /vision switch.
To run without laser you would need to add the /laserprobe switch.
After adding both switches, your finished shortcut would look something like this...
To run PC-DMIS without any vision functionality you would need to add the /vision switch.
To run without laser you would need to add the /laserprobe switch.
After adding both switches, your finished shortcut would look something like this...
