I'm new to PC DMIS and I'm having an issue where it seems like my manual alignment is not properly telling my DCC alignment where the features are.
I'll get a program up and running, and then I have to move the part to a different location on the table for one reason or another.
I run another manual alignment, go to run the program, and it doesn't work.
I was able to resolve the problem by re-setting my initial alignment and updating the dependent features, but my understanding is that I shouldn't have to do this every time and that it should do it automatically.
So I should re-measure all features after the DCC alignment and only dimension off of those, even if I measured those features in DCC mode before the DCC alignment?
So I should re-measure all features after the DCC alignment and only dimension off of those, even if I measured those features in DCC mode before the DCC alignment?