I'm new to PC DMIS and I'm having an issue where it seems like my manual alignment is not properly telling my DCC alignment where the features are.
I'll get a program up and running, and then I have to move the part to a different location on the table for one reason or another.
I run another manual alignment, go to run the program, and it doesn't work.
I was able to resolve the problem by re-setting my initial alignment and updating the dependent features, but my understanding is that I shouldn't have to do this every time and that it should do it automatically.
Manual alignment has 2 levels. That no worky ..... Bad habit to dimension anything before DCC alignment as well., It will bite you sooner or later. After DCC features, create DCC alignment and THEN , start creating additional features. THe postion of DATUM E is realted to your manual alignment not the DCC features. Thats just kind of a mess.....
LEVEL / ROTATE / And then X-Y-Z- 0.000 ( IN ANY ORDER )