Hi,
I'm trying to understand where does this issue come from.
We have 2 cmm et we've never had this message on the oldest (almost 3 years old).
Could it be an issue with the head ?
We had a crash but the problem started before the crash.
I also noticed presence of dust iron on the magnets (both head and styli), it was better after cleaning.
But sometimes the head lags (it stands still a few seconds, not reaching the time out but close enough)
When it reaches the time out we're screwed... because the CMM is used on an atomation production line...
Hi,
Both cmm are Tigo ?
Maybe there's a setting which is different between them (I don't know about fixed head, except LSPX5, but I don't remember a parameter like this...)
Hi,
Both cmm are Tigo ?
Maybe there's a setting which is different between them (I don't know about fixed head, except LSPX5, but I don't remember a parameter like this...)