i know how to input auto calibration in to the start of a program, i also know how to define my parameter set.
is there some script using flow commands after the auto calibration that would enable the program to review the auto calibration results and if they are over a certain standard deviation either stop the program or start the calibration again?
If there is a way, please post the script i would need to use including flow commands.
AUTOCALIBRATE/PROBE, PARAMETER_SET=90's, QUALTOOL_MOVED=NO,
CHECK COLLISION=NO, SHOW_SUMMARY=YES, OVERWRITE_RESULTSFILE=YES
BEGIN AUTOCALIBRATE RESULTS FOR PROBE LEITZ_TIP2BY40 USING SET 90's
END AUTOCALIBRATE RESULTS FOR PROBE LEITZ_TIP2BY40 USING SET 90's
this is a far as i have got
