Auto feature adaptive cylinder scan will not "complete"
It will complete when I "test" or when I execute the individual feature, but while running the entire program it will not complete and move onto the next step. IE, if I put a comment or incremental move immediately after the scanned auto feature, it will never get there.
Any suggestions? I'm lost, and new to analog scanning.
What does it to? Does it keep going around the cylinder indefinitely? Does it go partially around and then just sit there? Does it just go so slow you can't wait for it?
What does it to? Does it keep going around the cylinder indefinitely? Does it go partially around and then just sit there? Does it just go so slow you can't wait for it?