Sorry for bringing this subject back up, but I also wanted everyone to understand that my theory also applies to telling the machinist technically the same thing, when making adjustments. For instance right now, I have a part the holes he drilled are .0058 off in X and .0028 in Y. I will tell him to go .0058 in the correct direction of X and .0014 in the direction of Y. This is important not to use the full deviation in both directions.
Sorry for bringing this subject back up, but I also wanted everyone to understand that my theory also applies to telling the machinist technically the same thing, when making adjustments. For instance right now, I have a part the holes he drilled are .0058 off in X and .0028 in Y. I will tell him to go .0058 in the correct direction of X and .0014 in the direction of Y. This is important not to use the full deviation in both directions.