If that's the case, i would construct two end centroids on whatever is more important for the function of the part (ID bore or OD boss) then construct a 3d line between the two end-centroids. From there, construct your end planes. Pierce-point the 3d line into each plane. and make the distance between the pierce points..
If that's the case, i would construct two end centroids on whatever is more important for the function of the part (ID bore or OD boss) then construct a 3d line between the two end-centroids. From there, construct your end planes. Pierce-point the 3d line into each plane. and make the distance between the pierce points..
