I haven't viewed the pictures or anything but from what I gathered from the original post......
Its a distance measurement from the centroid of one circle to the other.
Each surface is at 15 degrees but parallel.
I'm assuming the holes are coaxial. based on the posts.
Could you not just align to the center axis of both holes in say the X axis then output the distance of the two circles projected to planes measured on each surface?
I don't understand the need for a complex offset angle alignment.
Am I missing something?
Also, I love how
Cliff claims to be the professional entity here.
I haven't viewed the pictures or anything but from what I gathered from the original post......
Its a distance measurement from the centroid of one circle to the other.
Each surface is at 15 degrees but parallel.
I'm assuming the holes are coaxial. based on the posts.
Could you not just align to the center axis of both holes in say the X axis then output the distance of the two circles projected to planes measured on each surface?
I don't understand the need for a complex offset angle alignment.
Am I missing something?
Also, I love how
Cliff claims to be the professional entity here.
