Your Products have been synced, click here to refresh
I haven't viewed the pictures or anything but from what I gathered from the original post......
Its a distance measurement from the centroid of one circle to the other.
We're not allowed to know if this is the case or not.
Each surface is at 15 degrees but parallel.
Yes - this is about all the information we've been given.
I'm assuming the holes are coaxial. based on the posts.
See my fist comment - that's a secret.
Could you not just align to the center axis of both holes in say the X axis then output the distance of the two circles projected to planes measured on each surface?
We don't know if they're circles or not - apparently looking end on is kind of looks like a rounded slot
I don't understand the need for a complex offset angle alignment.
From what we can all tell there isn't one
Am I missing something?
Whiskey
Also, I love how Cliff claims to be the professional entity here.
Not to worry good sir, your in Minnesota, I'll just drive up there spend $200 in gas money to get there. I'll figure all the GD&T out for you, Do I need to bring you a Coffee when I show up, If this is a complex part it may take a little time to write the program an such, please, I beg you to be patient, for I am not as fast as others are. I guess my question would be, how much do I need to pay you to do all of this for you? Just so I know if I have enough money for gas money to get back home?
© 2024 Hexagon AB and/or its subsidiaries. | Privacy Policy | Cloud Services Agreement |