Can anyone tell me what exactly this command does? Using 2020 R2
Other than putting SIMTOLX after my FCF I don't see anything different then if I didn't use it.
Many geometric tolerances are meant to be considered simultaneously. For example, when position and/or profile tolerances reference the same partially constrained datum reference frame, you should usually consider them simultaneously.
If you have a hole that is Ø6±0.1 with a TP of 0.1(M)|A|B(M)|C and another hole that is Ø4±0.1 with a TP of 0.2(M)|A|B(M)|C, it will evaluate both the holes together as they shift about Datum B.
If you go to Help in PC-DMIS and search for Simultaneous Tolerance, it will explain exactly what it is used for!
Many geometric tolerances are meant to be considered simultaneously. For example, when position and/or profile tolerances reference the same partially constrained datum reference frame, you should usually consider them simultaneously.
If you have a hole that is Ø6±0.1 with a TP of 0.1(M)|A|B(M)|C and another hole that is Ø4±0.1 with a TP of 0.2(M)|A|B(M)|C, it will evaluate both the holes together as they shift about Datum B.
If you go to Help in PC-DMIS and search for Simultaneous Tolerance, it will explain exactly what it is used for!
