Can anyone tell me what exactly this command does? Using 2020 R2
Other than putting SIMTOLX after my FCF I don't see anything different then if I didn't use it.
My issue is that I don't see any change in the True Position calculations with or without using the SIMTOL, am I missing something?
Can you give us some more information about what you are measuring? What types of feature? What are the datums? What is the print callout?
Without specifics, all I can offer is that If the DRF is fully constrained, there is no wiggle room for SIMTOL to shift anything. Maybe that is what is going on.
My issue is that I don't see any change in the True Position calculations with or without using the SIMTOL, am I missing something?
Can you give us some more information about what you are measuring? What types of feature? What are the datums? What is the print callout?
Without specifics, all I can offer is that If the DRF is fully constrained, there is no wiggle room for SIMTOL to shift anything. Maybe that is what is going on.
