When I create a linear open scan with “findnoms”, after I close the command and open it again it changes to “master”.
After I changed it a second time to "findnoms" it keeps that setting.
It doesn’t happen every time and I can’t reproduce it but it happened enough times,
that a coworker and I both noticed it independently on two different CMMs.
Does anybody have the same issue or maybe knows why this could happen?
I will continue to try and reproduce it but I’m happy for your input.
Aaron Baldauf No, that's about it, except for your reply of course - which was essential (I was hoping your issue would get some attention for it to be fixed) and judging by the reply from
Jdevaraj there is an issue.
Aaron Baldauf No, that's about it, except for your reply of course - which was essential (I was hoping your issue would get some attention for it to be fixed) and judging by the reply from
Jdevaraj there is an issue.