Wondering if there is another setting I am missing. Our CMM does not retract when taking manual hits.
I know of the F5 setting in the Part / Machine Tab. Doesn't matter what we put in there.
Went into the Settings Editor and changed that one to no avail.
I'm not at the cmm, I believe it depends on the controller.
On a B3CLC, I remember it didn't work except with a TTP.
On a DCxxx, I think you have to go in the DC control panel, then search in parameters.
I'm not at the cmm, I believe it depends on the controller.
On a B3CLC, I remember it didn't work except with a TTP.
On a DCxxx, I think you have to go in the DC control panel, then search in parameters.
