How can I add a CAD model to an existing program that was written without CAD? I realize that I'll have to transform/translate the model to get close to where the manual and DCC hits are shown in the program. So maybe a better question would be, how can I line up the model with the existing manual/DCC hits?
Put your cursor in your program after your final alignment and then grab a few points on the model where that alignment should be (one point for each axis). That will tell you exactly how much you need to translate the model.
Put your cursor in your program after your final alignment and then grab a few points on the model where that alignment should be (one point for each axis). That will tell you exactly how much you need to translate the model.
