I came across a print requirement too inspect TP of an open slot on a circular disk as shown in image attached.
what would be the correct way to inspect this?
Two "circles" on the radiis, construct midpoint/generic circle in order to utilize (M). Dimension the generic circle.
Good luck.
my first thought was the same but the issue arise because of the small portion of circle on both sides.
even a minor variation in diameter results in major deflection in center point.
Two "circles" on the radiis, construct midpoint/generic circle in order to utilize (M). Dimension the generic circle.
Good luck.
my first thought was the same but the issue arise because of the small portion of circle on both sides.
even a minor variation in diameter results in major deflection in center point.
