Im currently writing a program to inspect 4 parts on a fixture. Im looking for some help with creating a loop that has multiple alignments to reference to, but only loops 1 measurement routine (hole locations, planes, etc) and updates those theoretical locations based on which part is being measured. I have a input comment to the operator to say how many parts are being inspected, and made an assignment to that value. That value is then driving how many times the loop will cycle through. I just cant figure out how to make different alignments active, and update the features theoretical values.
Wow what a mess, Well you don't have your loop going in any directions after I finally found it in that hot Mess. Do as I showed above I will pull up some ol thread that you can look at.
Wow what a mess, Well you don't have your loop going in any directions after I finally found it in that hot Mess. Do as I showed above I will pull up some ol thread that you can look at.