Is there a way to pull the data from the axis measurements in Geometric Tolerances? I cannot seem to find the correct method to get that data. Is it possible?
Ok bfire85 what I discovered in Xactmeasure Probably the same for Geo, but when I created a position for 2 or more holes under Assignment this what you can extract, First pic, When you do single callouts, This is what you can extract, 2nd Pic
Ok bfire85 what I discovered in Xactmeasure Probably the same for Geo, but when I created a position for 2 or more holes under Assignment this what you can extract, First pic, When you do single callouts, This is what you can extract, 2nd Pic
