I have a problem, we measure the position of the pin and more precisely the position of the pin width.
3-3.2mm pos. 1 (M) DEF. In order to measure the pin, we have to base it on another element and turn the alignment by a certain degree. Then the center of the pin is X = 0, Z = 0
In the program, and placement on the machine the width is in the Z axis.
The question is whether we can report the position in the current alignment when we care about the left/right movement of the pin, where Z nominal is 0 and shows us our deviation (left/right)
So position, current alignemt, only axis Z.
Or do I have to choose datum reference, and XYZ.
seeker, What does your Feature Control Frame look like on the drawing? Where are those datums supposed to be located? I
almost always use the Datum Reference instead of current alignment, unless I'm doing something silly.
seeker, What does your Feature Control Frame look like on the drawing? Where are those datums supposed to be located? I
almost always use the Datum Reference instead of current alignment, unless I'm doing something silly.